On The Bench

#Merica#10" Macro#Get After It! Time to solder up esc's, motors, and camera then test and maiden flight.

I thought i share my progress of this build. it is the first time that i put together a partslist and go from there (done a tyro build before) Partslist : RDQ Source one Frame Emax Eco 2 motors 2807 1700kv RDQ Bardwell F7 Stack combo (which is a combo of joshua bardwell flightcontroller and iflig

i am fairly new to this hobby, but there is one thing i wanted from the beginning ,that is LONGRANGE. I live in iceland and my favourite thing is to record videos and pictures from the nature here , especiallt waterfalls (of which we have a ton of ) so my main purpose for fpv will be cinematic. af

I will literally buy the wrong props and build a drone around them. My woman says I'm addicted. I tell her at least it's not heroin... even though that would be cheaper.

I just organized and cleaned my workspace and got some new tools so this spot is looking better than ever. I want to see your dirtiest bench picture to make me feel better about how this spot used to look a few days ago hahaha 😝

Currently working on a MoonGoat build. It took me forever to finally get this frame. I ordered from two places. So I’ll likely have two identical builds. Frame: Cricket Moongoat Motors: Cricket Hypetrain 2306.6 1750kv - run these on all my freestyle quads Stack: Hobbywing G3 60 amp ESC RX: Crossfir

Guys, i would reallyyy appreciate some help here. I bought some 6s packs recently and put them on my build but i'm getting lots of fluttery high frequency oscillations. I tried to put the d term extremely low and it still wasn't working. I dropped the P lower also and it wasn't working to cut it out

Today I was out with my younger brother who is new to fpv, a guy approached us while I was plugged in and flying. I landed expecting him to be moaning about the sound or that I flew to close to him. He had approached as he had drove past seen we was up in the air and wanted to check what channels we

Getting this 3” Pixie closer to completion.

😅

This soldering tip can do just about any joint! What is Your favorite iron tip solution?!?!

I have started making a few of my own batteries out of 18650’s and need to know what is the voltage you would land at and also set the alarm in Betaflight?? Also an 8 pack I ordered had 2 batteries that were dead. One read .9v dc and the other read .5v dc. Is there anyway to revive these batteries?

About to start this build: T-Motor Velox 45A RunCam micro swift 3 T-motor-motor FT5 frame Unify PRO Race HV Radix2 FC Emax Eco motors