I thought i share my progress of this build.
it is the first time that i put together a partslist and go from there (done a tyro build before)
Partslist :
RDQ Source one Frame
Emax Eco 2 motors 2807 1700kv
RDQ Bardwell F7 Stack combo (which is a combo of joshua bardwell flightcontroller and iflight esc
Rushtank 2 800mw VTX
Matek M8Q Gps unit
Lumenier Long Range AX 2 Antenna
Immersion Rc ghost Atto Duo Antenna.
Starting on frame Assembly and dryfitting the stack to see how everything firs
Wanted to put the VTX in the back but it seems there is no mounting holes to fit it
so i am thinking on either doubletape and zipties or just putting it on top of the flight controller.
Also the stack screws that ame with the source one (did not like them) i replaced them.
looking good!
There are mounting holes underneath your capacitor for a 20x20 board. If you cut the legs down and angle the cap up a little bit, you can put some double sided mounting tape there, shrinkwrap the board, and run some small zipties through the holes to hold it in place