How it started vs how its going

Do you just solder it to the bottom and then assemble?

I guess that'd make sense, you'd have to pre fit to get the wire length right

I leave esc loose and then run wires under. I have room to move them around at that point.

Hid the motor wires so you can't see them. Look at red quad for how I wire motors just to keep more noise away from fc.

Thank you and to be honest I've only been flying Fpv for a lil over a year. And I never touched a soldering iron before..just a lot of practice..I've built over 50 quads in the year I've been flying..mostly for friends and people online

Real nice

Thank you took a while but I got better.. I use Rdq 63/37 solder and Kester 186 Liquid flux

Thanks buddy

That's great to hear! Thank you so much for helping us get this forum up and running.