I usually lay everything out on the table. Make sure I have everything I need. Build up the Frame first Then I'll do a dry fitting of electronics and see how Id mount it including Power leads and where they will go. Toss on the motors Solder on power leads on esc - then mount to frame Measure 3 or 4 times the motor wires with a slight extra slack Then take it from there to fc
I usually lay everything out on the table. Make sure I have everything I need. Build up the Frame first Then I'll do a dry fitting of electronics and see how Id mount it including Power leads and where they will go. Toss on the motors Solder on power leads on esc - then mount to frame Measure 3 or 4 times the motor wires with a slight extra slack Then take it from there to fc